License Plate Frame Installation and Fitment Guide
By DeatschWerks | Published: 2026-10-21
Category: Product Reviews
Learn how to install your DeatschWerks License Plate Frame with our step-by-step guide. Covers fitment, mounting tips, and common mistakes to avoid for a clean look.
Quick answer
Installing the DeatschWerks License Plate Frame is a straightforward process that requires basic hand tools and attention to fitment details to avoid rattles or damage to your plate.
Why fitment matters for your license plate frame
While most license plate frames are designed for standard plates, slight variations in plate thickness or mounting hole placement can affect fit. The DeatschWerks frame uses a standard fit, but checking alignment before final tightening saves you from crooked or loose installation.
A well-fitted frame protects your plate edges from bending and reduces vibration noise. Taking a few extra seconds during alignment pays off in long-term appearance and durability.
Step-by-step installation guide
- 1. Gather tools and inspect the frame: You'll need a screwdriver (Phillips or flathead depending on your vehicle), the DeatschWerks frame, and your license plate. Check that the frame's mounting holes align with your plate's holes and that no burrs or sharp edges exist on the frame. Common mistake: Using the wrong screwdriver tip can strip the screws. Match the driver to your vehicle's hardware.
- 2. Position the plate inside the frame: Slide the license plate into the frame, ensuring the plate sits flush and centered. The DW logo should be oriented correctly (usually readable from behind the vehicle). Checkpoint: Confirm the plate is not bent or warped before inserting. A bent plate will cause the frame to sit unevenly.
- 3. Align and attach to the vehicle: Hold the frame-and-plate assembly against the mounting points on your bumper or trunk. Insert the screws through the frame holes, then through the plate, and into the vehicle's threaded inserts. Tighten each screw gradually in a cross pattern to distribute pressure evenly. Common mistake: Overtightening can crack the frame or strip the threads. Tighten until snug, then stop.
- 4. Final check and adjustment: After all screws are tight, gently wiggle the frame to ensure it's secure. Check that the frame does not obscure any required plate text or registration stickers. If the frame rattles, add thin rubber washers between the frame and the plate. Checkpoint: Verify that the frame does not interfere with trunk or hatch operation if mounted on a moving panel.
Product details
- DW License Plate Frame: Standard fit for most license plates with durable construction intended for long-term use. You won't need special tools or modifications for typical plates, and the frame stays secure over time.
DW License Plate Frame
