What This Kit Is Designed For
The DeatschWerks X2 Series Pump Module -8AN PTFE Plumbing Kit is purpose-built for the 2011–19 Ford Mustang. It replaces the factory fuel lines with a -8AN PTFE hose and plumbing, supporting higher fuel flow for modified engines. This guide explains what the kit includes and how to plan your installation using the supplied evidence.
What the Catalog Confirms
- X2 Series Pump Module -8AN PTFE Plumbing Kit for 2011-19 Ford Mustang: The kit is designed for 2011–19 Ford Mustang vehicles, part of DeatschWerks Fuel Pump Plumbing Kits (SKU 6-604). Vehicle fitment is confirmed; no adapter plates or modifications are required for the listed model years.

X2 Series Pump Module -8AN PTFE Plumbing Kit for 2011-19 Ford Mustang - X2 Series Pump Module -8AN PTFE Plumbing Kit for 2011-19 Ford Mustang: The kit uses -8AN PTFE hose and fittings, which are compatible with ethanol-blended fuels and resist permeation. PTFE (Teflon) lining is important for high-horsepower builds and E85 compatibility, making this a durable choice.
Planning Your Installation
Before you start, confirm that your Mustang is a 2011–19 model and that your fuel system is ready for the upgrade. The kit does not include a pump module or fuel pump; you need a compatible DeatschWerks X2 pump module separately.
- Check vehicle compatibility: The kit is confirmed for 2011–19 Ford Mustang. Double-check your chassis year and engine configuration.
- Gather tools and safety gear: You'll need standard wrenches for AN fittings, a PTFE hose cutter, and safety glasses. Work in a well-ventilated area with the battery disconnected.
- Plan hose routing: The -8AN PTFE hose is less flexible than rubber hose; plan a route that avoids sharp bends and hot exhaust components. Use the factory line paths as a reference.
Installation Process
The following steps outline the general procedure. The catalog does not provide step-by-step instructions, so treat these as a logical sequence based on the kit's design.
- Remove factory fuel lines: Relieve fuel pressure, then disconnect the stock lines from the fuel rail and pump module. Cap open ports to prevent debris entry.
- Install the X2 pump module: The plumbing kit connects to a DeatschWerks X2 Series pump module. Install the module per its own instructions before routing the new hose.
- Cut and assemble PTFE hose: Measure and cut the -8AN PTFE hose to length. Use a dedicated PTFE cutter to avoid fraying. Assemble the hose ends with the supplied fittings, tightening to manufacturer torque specs.
- Route and secure the hose: Run the hose from the pump module to the fuel rail, avoiding contact with moving parts or heat sources. Use cushioned clamps to secure the hose at intervals.
- Connect and test: Attach the hose to the module and fuel rail. Prime the system by cycling the key (without starting) and inspect for leaks. Start the engine and re-check connections.
Honest Trade-Offs to Consider
PTFE hose is more rigid and harder to route than rubber or nylon hose. Plan extra time for measuring and test-fitting. The kit does not include a fuel pump or module, so you need to purchase those separately. Also, -8AN line may be oversized for a stock engine; it's intended for builds with increased fuel demand.


